Photon Mono M7 Max + TPE
Optimized print parameters for Anycubic Photon Mono M7 Max with TPE filament.
| Parameter | Value | Note |
|---|---|---|
| Nozzle Temperature | 200°C | Range: 200-230°C |
| Bed Temperature | 30°C | Range: 30-50°C |
| Print Speed | 20 mm/s | Max: 0 mm/s |
| Outer Wall Speed | 15 mm/s | Slower for surface quality |
| Inner Wall Speed | 20 mm/s | |
| Layer Height | 0.04 mm | Nozzle: 0 mm |
| First Layer Speed | 15 mm/s | Slower for adhesion |
| Retraction | 1.3 mm @ 45 mm/s | Bowden |
| Flow Rate | 0.95 | Fine-tune with flow test |
| Walls / Top / Bottom | 4 / 5 / 4 | Shell structure |
| Infill | 39% gyroid | Adjust for strength |
| Fan Speed | 60% (start layer 3) | Full after first layer |