X-Plus 3 + PVA
Optimized print parameters for QIDI X-Plus 3 with PVA filament.
| Parameter | Value | Note |
|---|---|---|
| Nozzle Temperature | 196°C | Range: 180-210°C |
| Bed Temperature | 53°C | Range: 45-60°C |
| Print Speed | 47 mm/s | Max: 600 mm/s |
| Outer Wall Speed | 23 mm/s | Slower for surface quality |
| Inner Wall Speed | 37 mm/s | |
| Layer Height | 0.16 mm | Nozzle: 0.4 mm |
| First Layer Speed | 15 mm/s | Slower for adhesion |
| Retraction | 0.9 mm @ 30 mm/s | Direct drive |
| Flow Rate | 0.95 | Fine-tune with flow test |
| Walls / Top / Bottom | 4 / 5 / 4 | Shell structure |
| Infill | 39% gyroid | Adjust for strength |
| Fan Speed | 93% (start layer 2) | Full after first layer |