M5C + PC
Optimized print parameters for AnkerMake M5C with PC filament.
Warning: PC requires an enclosure for best results. The M5C does not have a built-in enclosure. Consider adding an aftermarket enclosure or printing in a draft-free environment.
| Parameter | Value | Note |
|---|---|---|
| Nozzle Temperature | 297°C | Range: 260-310°C |
| Bed Temperature | 100°C | Range: 100-120°C |
| Print Speed | 47 mm/s | Max: 500 mm/s |
| Outer Wall Speed | 23 mm/s | Slower for surface quality |
| Inner Wall Speed | 37 mm/s | |
| Layer Height | 0.16 mm | Nozzle: 0.4 mm |
| First Layer Speed | 15 mm/s | Slower for adhesion |
| Retraction | 0.5 mm @ 36 mm/s | Direct drive |
| Flow Rate | 0.95 | Fine-tune with flow test |
| Walls / Top / Bottom | 4 / 5 / 4 | Shell structure |
| Infill | 39% gyroid | Adjust for strength |
| Fan Speed | 0% (start layer 999) | Low for enclosed materials |